Kodak ESP 9 - Manual (Page 52)

44 www.kodak.com/go/aiosupport
4
Handling Paper
Your Kodak All-in-One printer accepts print stock of various types and sizes,
including letter- and legal-size plain paper, photo paper, transparencies, T-shirt
transfers, envelopes, cards, and labels. It automatically detects the size and whether
or not photo paper is loaded into the paper tray. Kodak photo paper contains
barcodes that allow your All-in-One printer to detect the paper type that optimizes
your photo prints.
The bottom paper tray accepts media from 6 to 9 inches wide, and from 7 to 14
inches long (see the Note in
Loading plain paper, page 45 ); its capacity is 100 sheets
of 20 lb. plain paper. The top tray capacity is 40 sheets of 4X6, 4X7, or 5X7 inch
paper.
The automatic document feeder (ADF) on the ESP 9 All-in-One printer accepts up
to 35 sheets of plain paper.
Handling paper
Follow the precautions below when handling paper:
• Hold the paper by the edges; avoid placing your fingerprints on it.
• Do not touch the glossy side of photo paper.
• Store paper flat, away from direct sunlight and heat (such as in a car parked in
the sun).
Loading the paper trays
Things to keep in mind
• Before you start loading any type of media into the printer, lift the paper output
tray.
• Pull the paper stop (at the edge of paper output tray) until it is fully extended.
• If the paper you are going to use is less than A4 size, lift the hinged end of the
paper stop toward you until it perpendicular to the paper stop. This prevents
the printed paper from sliding off of the paper output tray as it exits the
printer.
WARNING: The printer cannot sense photo paper loaded in the automatic
document feeder (ADF) and will not feed photo paper into the printer for
either copy (document) or fax operations.