Kodak ESP 9 - Manual (Page 117)

www.kodak.com/go/aiosupport 109
Kodak ESP 9 All-in-One printer
• If there are metal objects (such as a metal bookcase or refrigerator) in the
transmission path, clear the path between the printer and the computer or
access point.
• If a cordless telephone, microwave, or other device that emits radio signals
transmitting at 2.4 GHz is nearby, move it farther away to reduce radio
interference. See the note on
page 111 .
Cannot connect to network
Probable Cause 1
The equipment is not turned on.
Corrective Action
Turn on the networked devices, such as the access point for an infrastructure
network, or the computer for an ad hoc network. For more information on how to
turn on the access point, see the documentation that came with your access point.
Probable Cause 2
The All-in-One printer is not receiving a signal.
Corrective Action
Move the access point and the printer closer together. Then go through setup again.
Probable Cause 3
You have entered the SSID incorrectly.
Corrective Action
Enter the SSID correctly. Remember that the SSID is case-sensitive.
Probable Cause 4
You have entered the WEP key incorrectly.
Corrective Action
Enter the WEP key correctly. Remember that the WEP key is case-sensitive.
Probable Cause 5
The wireless settings on the printer do not match the wireless settings of your
access point.
Corrective Action
Print a network configuration page to compare the wireless settings of the printer
with the wireless settings for your access point. Change either the device or access
point settings so that both the printer and the access point have matching wireless
settings.
Probable Cause 6
You entered the wrong mode (ad hoc or infrastructure) or security type.