Regulatory compliance, Fcc compliance and advisory – Kodak ESP 9 User Manual
Page 128
Product and Safety Specifications
120
www.kodak.com/go/aiosupport
CAUTION:
Adjust only those controls covered in the user guide or setup instructions.
For more information, go to
www.Kodak.com/go/MSDS
.
Regulatory Compliance
FCC Compliance and Advisory
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed or used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, you are encouraged
to try to correct the interference by one or more of the following measures: 1)
reorient or relocate the receiving antenna; 2) increase the separation between the
equipment and the receiver; 3) connect the equipment to a different outlet (on a
circuit) than the one the receiver is connected to; 4) consult the dealer or an
experienced radio/TV technician for additional suggestions.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. To ensure
compliance with FCC regulations, use only the shielded interface cables provided
with the product, or additional specified components or accessories that can be
used with the installation of the product.
CAUTION:
When using the Bluetooth interface with a Kodak printer, the transmitter
must not be collocated or operated in conjunction with any other antenna or
transmitter.