Kodak ESP 9 - Manual (Page 25)

www.kodak.com/go/aiosupport 17
Kodak ESP 9 All-in-One printer
Printer Power Cord Light
Light Status Cause Action / Solution
Off The printer power cord is not
properly connected to the
printer. Reconnect the printer power cord plug
to the printer.
The electrical power cord is not
properly connected to your
electrical outlet. Reconnect the cord to the electrical
outlet. Ensure that the electrical power
cord is fully connected to the
alternating current (AC) adapter at the
end of the printer power cord.
The electrical outlet has no
power. Plug a working device into the wall
outlet to test it, or have it checked by an
electrician.
The problem may lie with the
power supply. Check the power supply status light, if
available. As needed, visit Kodak.com
for additional troubleshooting steps, or
contact Kodak Service & Support.
On The power supply is supplying
power to the printer. None.
Memory Card Slot Light
Light Status Cause Action / Solution
Off Either the memory card is not
inserted or is improperly inserted in
the card slot. Remove and reinsert the memory
card.
Blinks The internal card reader is
initializing or communicating with a
memory card. None.
On A memory card is properly inserted
in the card slot. None.