Kodak ESP 9 - Manual (Page 26)

Printer Overview
18 www.kodak.com/go/aiosupport
Attention Light
Light Status Error
Off None.
Blinks (slow)
The LCD screen
describes the error.
Paper jam.
Paper tray empty.
Paper carriage stall.
Paper size or type mismatch.
Change ink cartridge.
Ink cartridge not readable.
Printhead not calibrated.
Unit open, scanner lid open, rear access door open.
Too many image sources.
Printhead not installed.
Unable to read memory card or USB host device.
Blinks (slow) Ink cartridge(s) inserted incorrectly.
Ink cartridge(s) not installed.
On Media sensor failure.
Printhead failure.
Scanner failure.
Wi-Fi Light
Light Status Cause Action / Solution
Off This indicates that the Wi-Fi radio is
turned off and the printer is not
connected to a wireless network. None.
Blinks
continuously The Wi-Fi radio is turned on and the
printer is searching for available
wireless networks within range. None, unless you want to stop
the connection process. If so,
turn the Wi-Fi radio off.
Blinks
intermittently
The LCD
screen
displays an
error message
The Wi-Fi radio is turned on and:
• The printer cannot find any available
wireless networks within range.
or
• The Wi-Fi network connection has
been interrupted, or is too weak to
send signals to and from the printer.
Press OK to turn off the error
message on the LCD screen
and then turn the Wi-Fi radio
off.
Run the Wi-Fi Setup Wizard to
find and connect to an
available wireless network
within range.
a
On The Wi-Fi radio is turned on and there
is a working connection between the
printer and a wireless network. None.