KORG TouchView Trinity ProX - Manual (Page 12)

Overview
8
Sequencer
Insert Effects
The Insert Effects selected in Program Edit mode are not used in Sequencer mode. Instead, you can set
Insert Effects for up to eight Tracks in the Sequencer.
Go to P7 in Sequencer mode, and set the Insert Effect’s Off, size (1, 2, 4, 8), and grouping parameters for
each of Tracks 1–16.
If you wish to use a Program’s Insert Effect settings by using the Copy function, first select a size for the
corresponding Track equal to or greater than the size of the effects used in the Program.
You can route up to three Insert Effects for each Track in series . (If the Program is using a DrumKit, you
can use up to four effects in series or parallel .)
The total effect size for all the Tracks must be eight or less .
You can also set the total effect size for a single Track to eight. However, if you are routing three Insert
Effects in series, you cannot place an effect of size 4 on the second position. For a Track that uses a Drum
mode Program, you can set the total effect size to eight. However, if you are routing three Insert Effects in
series, you cannot place an effect of size 4 on the second position. If you are routing four effects in series,
you cannot place an effect of size 4 on the second or third position.
If you insert a size 1 effect, the input/output becomes monaural. In this case, the Track’s Pan parameter
(P1 Track Play/Rec in Sequencer mode) becomes ineffective, and the pan setting will be in the center.
Adjust the stereo pan position using the Pan parameter (P7 in Sequencer mode) that comes after the
Insert Effects.
If the Insert Effect output is in stereo, you can control the width of the effect (such as the width of rever-
beration) using the Width parameter (P7 in Sequencer mode). If you wish to make the oscillator’s Pan set-
ting (P5 in Program Edit mode) effective, set the Pan setting that comes after the Insert Effects to C064
and set the Width to 127.
Refer to the “Program - Drums OSC mode” section for information regarding the setting of Programs that
use a DrumKit.
OSC1 Filter1 Amp1
OSC2 Filter2 Amp2
E1 E2 E3
Send1
Send2
Pan Width
Send1
Send2
Pan
Send1
Send2
Pan
Insert Effects LEQ HEQ
Return1 Return2
Track Play / Rec
(Sequencer P1)
Master Effects
Insert Effect Grouping
(Sequencer P7) Master Effects
(Sequencer P8)
OUT1
OUT2
Insert Effect=Off
Sequencer
Low Gain High Gain
Pan1
Pan2
OUT3
OUT4
OSC1 Filter1 Amp1
OSC2 Filter2 Amp2
Send1
Send2
Pan
Send1
Send2
Pan
Track1
Track2
Track16
up to
E1 E2 E3
Send1
Send2
Pan Width
Insert Effects
Assigning/Grouping Track to Insert Effects
Insert Effect=Off
Modulation
Reverb/Delay
in the case of
Insert Effect =Off
in the case of
Insert Effect =On
in the case of
Insert Effect =Off
in the case of
Insert Effect =On
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+ +
+ +
+
+
+
+
+
+
+ +
+ +