KORG TouchView Trinity ProX - Manual (Page 57)

05: OD/Hi-Gain Wah (Overdrive/Hi-Gain Wah)
53
size2
05: OD/Hi-Gain Wah
(Overdrive/Hi-Gain Wah)
This effect is a distortion with wah, 4-band EQ and amp simulator.
a
Wah Off, On Switches Wah on/off. ☞ P.54
Src None…Tempo Modulation source that controls the Wah.
b Wah Sweep Range –10…+10 Sets the range of Wah. ☞ P.54
c
Drive Mode Overdrive, Hi-Gain Switches between overdrive and hi-gain distortion.
Pre Low-cut 0…10 Low range cut amount of the distortion input ☞ P.19
d
Drive 1…100 Sets the degree of distortion. ☞ P.19
Output Level 0…50 Sets the output level.
e
Band1 Cutoff [Hz] 20…1.0kHz Equalizer - Band 1 center frequency
Q 0.5…10.0 Band 1 bandwidth ☞ P.19
Gain [dB] –18…+18dB Band 1 gain
f
Band2 Cutoff [Hz] 50…5.00kHz Band 2 center frequency
Q 0.5…10.0 Band 2 bandwidth ☞ P.19
Gain [dB] –18…+18dB Band 2 gain
g
Band3 Cutoff [Hz] 300…10.00kHz Band 3 center frequency
Q 0.5…10.0 Band 3 bandwidth ☞ P.19
Gain [dB] –18…+18dB Band 3 gain
h
Band4 Cutoff [Hz] 500…20.00kHz Band 4 center frequency
Q 0.5…10.0 Band 4 bandwidth
☞
P.19
Gain [dB] –18…+18dB Band 4 gain
i
Direct Mix 0…50 Amount of the dry sound mixed to the distortion
Speaker Simulation Off, On Speaker simulation on/off
j
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Amp Simulation
4 Band PEQ
Output Level
Direct Mix
Pre Low-cut
D -mod
Wah
Mode: Overdrive / Hi-Gain
Drive
Driver