KORG TouchView Trinity ProX - Manual (Page 9)

Overview
5
If output connectors 3 and 4 are used for stereo output, you can set the stereo position of Send 1 and 2
using the Pan 3 and 4 parameters (P8 in Program Edit mode).
To set the Master Effect return level, use the Return 1 and 2 parameters (P8 in Program Edit mode).
If you check the check box located between Send 1 and Send 2 in the upper left corner of the LCD, the
serial routing of Modulation
→ Reverb/Delay will be added. That is, the Right modulation output will be
added to the Reverb/Delay input. In this case, you can still set the Return 1 and 2 parameters indepen-
dently.
Program - Drums OSC mode
Insert Effects
You can insert up to four effects in series or parallel as long as the total of the effect sizes is four or less
when you are using a Drum mode Program (shown as E1, E2, E3, and E4 in the center of the figure
above).
You can select Insert On/Off, and inst 1–4 (using E1–E4 input), and set the Pan and Send 1/2 parameters
for each Drum sound in P5 of Global mode for each key. The final send setting will use the value set here
multiplied by the Send setting set in P5 of Program Edit mode.
If you insert a size 1 effect, the input/output becomes monaural. In this case, the DrumKit’s Pan parame-
ter (P5 in Global mode) becomes ineffective, and the sound will be panned in the center. Adjust the stereo
position using the Pan parameter (P5 of Program Edit mode) that comes after the Insert Effects (P7 in Pro-
gram Edit mode).
If the Insert Effect output is in stereo, you can control the width of the effect (such as the width of rever-
beration) using the Width parameter (P7 in Program Edit mode). If you wish to make the DrumKit’s Pan
setting (P5 in Global mode) effective, set the Pan setting that comes after the Insert Effects to C064 and set
the Width to 127.
Master Effects
The input level of the Master Effects is set by Send 1 and 2.
Since the destination of the send routing changes depending on whether the Insert Effects have been
inserted or not, the parameters will change accordingly.
Kick
Snare
E1
Send1
Send2
Pan Width
Send1
Send2
Pan
Send1
Send2
Pan
Insert
Effects
+
+
+
+
LEQ HEQ
Return1 Return2
Amp1/2 Mod
(Program Edit P5)
Master Effects
Insert Effects
(Program Edit P7) Master Effects
(Program Edit P8)
OUT1
OUT2
Insert Effect=Off
Insert Effect=inst1
Insert Effect=Off Program - Drums OSC Mode
Low Gain High Gain
Pan1
Pan2
OUT3
OUT4
Send1
Send2
Send1
Send2
Send1
Send2
Pan Width
Pan Width
Pan Width
E2
E3
E4
+
+
Tom
H.Hat
Send1
Send2
Pan
Send1
Send2
Pan
Insert Effect=inst2
Insert Effect=inst3
Send1
Send2
Pan
Insert Effect=inst4
Conga
DrumKit
(Global P5)
Inst1/2/3/4 ->E1/E2/E3/E4
Modulation
Reverb/Delay
Send1
Send2
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+ +
+ +
+
+
+ +
+
+
+ +
+
+
+
+
+
+
+
+
+
+
+