KORG TouchView Trinity ProX - Manual (Page 32)

11: Decimator
28
11: Decimator
This effect creates a rough sound like a cheap sampler by lowering the sampling frequency. You can also
simulate noise unique to a sampler (aliasing).
a Pre LPF Off, On
Selects whether the harmonic noise caused by decrease
in sampling frequency is generated or not.
☞
P.28
b
Sampling Freq [Hz]
(Sampling Frequency)
1.00k…24.00kHz Sets the sampling frequency.
Src None…Tempo Sets the modulation source of the sampling frequency.
Amt –24.00k…+24.00kHz Sets the modulation amount of the sampling frequency.
c High Damp [%] 0…100% Ratio of cut of the high range
d
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
a: Pre LPF If you input a sound containing high frequencies (that cannot be sampled) to a
sampler with a low sampling frequency, a noise with a pitch unrelated to the
original sound will be generated. When Pre LPF = ON, this type of noise will
not be generated.
You can create a sound similar to a ring modulator if you set Pre LPF to OFF,
with a Sampling Freq of 3kHz.
In
Wet / Dry
Mono In - Mono Out
Pre LPF High Damp
Decimator
Sampling Frequency