KORG TouchView Trinity ProX - Manual (Page 21)

03: Gate
17
size1
03: Gate
The Gate effect mutes signals with a level lower than the specified threshold. You can also use this effect
to create Gated Reverb by routing it after the Reverb effect. The Gate can be turned on/off directly by
Note On/Off.
a
Envelope Select D-mod, Input
Toggles between control by Modulation Source and con-
trol by input signal.
☞ P.17
Src None…Gate2+Sus
Modulation Source that controls Gate when Envelope
Select is set to D-mod.
b Threshold 0…100
Sets the signal level below which Gate is applied.
☞ P.17
c Attack 1…100 Sets attack time. ☞ P.17
d Release 1…100 Sets release time. ☞ P.17
e Delay Time [msec] 0…100msec Delay time for gate input ☞ P.18
f
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
a: Envelope Select
a: Src The Envelope Select parameter determines whether the Gate is on/off based on
the level of input signal or by using a modulation source. The Src parameter is
available only when you have selected D-mod for the Envelope Select parame-
ter. Selection ranges from None to Gate2+Sus.
b: Threshold
c: Attack
d: Release This parameter sets the signal level below which Gate is applied when Envelope
Select is set to Input.
The Attack and Release parameters set the Gate attack time and release time.
In
Wet / Dry
Mono In - Mono Out
Gate
Envelope Select
Envelope - Control
Delay
Gate+Sus