KORG TouchView Trinity ProX - Manual (Page 8)

Overview
4
Program
You can use the Insert Effects as long as the total of the effect size is four or less in Program mode.
The configuration of the Insert Effects is different when using a Single or Double mode Program than
when using a Drum mode Program.
Program - Single/Double OSC mode
Insert Effects
You can insert up to three effects in series as long as the total of the effect sizes is four or less when you
are using a Program with the Oscillator Mode parameter (1–1c) set to single or double (shown as E1, E2,
and E3 in the center of the figure above).
If you insert a size 1 effect, the input/output becomes monaural. In this case, the oscillator’s Pan parame-
ter (P5 in Program Edit mode) becomes ineffective, and the pan setting will be in the center. Adjust the
stereo pan position using the Pan parameter that comes after the Insert Effects (P7 in Program Edit mode).
If the Insert Effect output is in stereo, you can control the width of the effect (such as the width of rever-
beration) using the Width parameter (P7 in Program Edit mode). If you wish to make the oscillator’s Pan
setting (P5 in Program Edit mode) effective, set the Pan setting that comes after the Insert Effects to C064
and set the Width to 127.
Master Effects
The input level of the Master Effects is set by Send 1 and 2.
Since the destination of the send routing changes depending on whether the Insert Effects have been
inserted or not, the parameters will change accordingly.
If you have inserted Insert Effects, the Send 1 and 2 parameters of P7 in Program Edit mode will become
effective (those of P5 will be ignored). If you have not inserted Insert Effects, the Send 1 and 2 parameters
of P5 in Program Edit mode will become effective.
The Send 1 and 2 parameters are also used to set the level of the signal appearing at output connectors 3
and 4.
Only the Master Effect sound will be sent to output connectors 3 and 4. If you wish to output dry sound
(without the Master Effects applied), set the Master Effect parameters of P8 in Program Edit mode to
“Off.” In this case, however, the Master Effects will not be applied to the signal at outputs 1 and 2.
OSC1 Filter1 Amp1
OSC2 Filter2 Amp2 E1 E2 E3
Send1
Send2
Pan Width
Send1
Send2
Pan
Send1
Send2
Pan
Insert Effects LEQ HEQ
Return1 Return2
Amp1/2 Mod
(Program Edit P5)
Master Effects
Insert Effects
(Program Edit P7) Master Effects
(Program Edit P8)
OUT1
OUT2
Insert Effect =Off *
Program - Single / Double OSC Mode
Low Gain High Gain
Pan1
Pan2
OUT3
OUT4
Modulation
Reverb/Delay
in the case of
Insert Effect =Off *
in the case of
Insert Effect =On
+ +
+ + +
+
+
+
+ +
+
+
+
+
+
+
* Insert Effect =Off: size =0
Right Left Center
Pan=C064, Width=127
Pan=C064, Width=64
Pan=C064, Width=32
Pan=C064, Width=0
Pan=L000 Pan=R127
Insert Effect - Pan, Width
Right Left Center
Pan=C064, Width=127
Pan=L048, Width=127
Pan=L032, Width=127
Pan=L016, Width=127
Right Left Center
Pan=R096, Width=127
Pan=R096, Width=64
Pan=L048, Width=127
Pan=L048, Width=64
Pan=L000 Pan=R127 Pan=L000 Pan=R127