KORG TouchView Trinity ProX - Manual (Page 131)

06: Multitap Chorus/Dly (Multitap Chorus/Delay)
127
size4
i
Tap1 Feedback –100…+100 Tap1 feedback amount
Src None…Tempo
Modulation source for the Tap output level, feedback
amount, and effect balance
☞ P.127
Amt –100…+100 Modulation amount of Tap1 feedback amount ☞ P.127
j
Wet/Dry Dry, 1:99…99:1, Wet Balance between effect sound and dry sound
Amt –100…+100 Modulation amount of effect balance ☞ P.127
b: Status
c: Status
d: Status
e: Status
f: Status
g: Status These parameters set the output status of each Tap.
Always On: Output is always on. (No modulation)
Always Off: Output is always off. (No modulation)
On
→ Off (dm): Output level is switched from on to off depending on the modu-
lation source.
Off
→ On (dm): Output level is switched from off to on depending on the modu-
lation source.
Combining these parameters, you can change from 4-phase chorus to two-tap
delay by crossfading them gradually via the modulation source during a perfor-
mance.
h: Panning Preset This parameter selects combinations of stereo images of the tap outputs.
i: Src
i: Amt
j: Amt Tap output level, feedback amount and effect balance are controlled simulta-
neously via a modulation source.