Kyocera KM-C1530 - Manual (Page 197)

Administrator Mode Operations 8
KM-C1530 8-27
To set the “PRT Area (Top Margin)” parameter
This parameter can be used to adjust the paper feed position in the
secondary scanning direction when making single-sided copies. In
addition, this can be adjusted for each paper type. This parameter can be
set between –2.0 mm and +2.0 mm, in increments of 0.2 mm.
Note)
✔ This adjustment affects paper loaded into the standard paper drawer,
the manual bypass tray, the optional 500-sheet paper feed unit, and
the optional large-capacity cabinet.
✔ The multipurpose paper drawer (1st drawer) is the tray that is checked
and adjusted.
✔ The top margin of the print area is adjusted during manufacturing of
the copier. Normally, the top margin will not need to be adjusted.
1 In the Expert User’s Mode screen,
touch [2/2], and then touch [PRT Area
(Top Margin)].
The Top Margin screen appears.
2 Load paper (11 × 17L) into the 1st
drawer, and then press the [Start] key
to print out the test pattern.
The screen at the right is displayed if
the paper type dial on the 1st drawer
is set for normal paper.