Kyocera KM-C1530 - Manual (Page 248)

9 Touch Panel Messages
9-44 KM-C1530
9.9 Other Messages
Message Cause Remedy
Malfunction detected.
Call your Technical Rep. and
provide code: The copier malfunctioned
and is unable to make
copies. Inform your technical
representative of the code
displayed on the touch
panel.
Please input your 4-digit
Access# and press the
Access key. Access codes have been
specified. Copies cannot be
made unless a specified
access code is entered. Enter your access code.
p. 2-28
Replenish paper. The indicated drawer has ran
out of paper. Load paper into the indicated
drawer. p. 9-1
Please add Toner.
Open the Toner Supply Door
and follow the Operator’s
Manual. Since the toner for the
indicated color has run out,
the copier is unable to make
copies. Refill the toner. p. 9-6
Please add XXXX Toner. The toner for the indicated
color is about to run out. Refill the toner. p. 9-6
Please install the correct
Imaging
Unit correctly, and close all
doors. The indicated imaging unit is
not installed correctly. Correctly install the imaging
unit. Otherwise, contact your
technical representative.
Please insert the Image
Transfer
Belt Unit and close all doors. The image transfer belt unit
is not installed correctly. Contact your technical
representative.
Please insert Waste Toner
Bottle
and close all doors. The waste toner bottle is not
installed correctly. Correctly install the waste
toner bottle. Otherwise,
contact your technical
representative.
Please insert the Fusing Unit
and
Fusing Web Unit and Oil
Coating Unit
and close all doors. The fusing unit, fusing web
unit, and oil-coating unit are
not installed correctly. Correctly install the fusing
unit, fusing web unit, and oil-
coating unit. Otherwise,
contact your technical
representative.
Close ➜ Section properly. Since a copier door or cover
is open or an option is not
installed correctly, the copier
is unable to make copies. Make sure that all doors and
covers are closed and that all
options are installed
correctly.
Replace Staple Cartridge X. The staples have run out. Replace the staple cartridge.
p. 9-11
Misfeed detected.
Remove misfeed at O. Since a paper misfeed
occurred, the copier is
unable to make copies. Clear the paper misfeed.
p. 9-16
The Exit Tray has reached its
capacity. Please remove all
pages from -> section tray. Since the maximum amount
of copies for the indicated
finisher tray has been
exceeded, the copier is
unable to make copies. Remove all copies from the
indicated tray.