Kyocera KM-C1530 - Manual (Page 201)

Administrator Mode Operations 8
KM-C1530 8-31
To set the “PRT Area (Dup. Left Margin)” parameter
This parameter can be used to adjust the printing position in the
secondary scanning direction when making double-sided copies.
This parameter can be set between –3.0 mm and +3.0 mm, in increments
of 0.2 mm.
This adjustment affects the main unit and any optional paper drawers.
The left margin of the print area for the first and second paper drawers is
adjusted during manufacturing of the copier. Normally, the left margin will
not need to be adjusted.
As an example, the following procedure describes how to adjust the left
margin for the fourth paper drawer.
Note)
✔ In order to print a test pattern on paper loaded into the paper drawer
that you wish to check and adjust, the appropriate paper drawer must
be specified in advance. Refer to “Selecting the Paper Source” on
page 5-4.
1 Load paper (11 × 17L) into the fourth paper drawer.
2 In the Expert User’s Mode screen,
touch [2/2], and then touch [PRT Area
(Dup. Left Margin)].
The Dup. Left Margin screen
appears.
3 Touch [4th Drawer], and then press
the [Start] key to print out the test
pattern.