2 change 80211 antenna, 2 change 80211 antenna -3 – Lantronix MSS User Manual
Page 12
Command Reference
Change 80211
2-3
Defaults
Enabled
See Also
2.2.2 Change 80211 Antenna
Controls the antenna(s), if any, on the installed wireless card. Not all antennas can be used for both receive
and transmit, so be sure to read your card documentation completely. The default settings should work in
most applications.
Any configuration changes you make with the above commands will not take place until you issue the
Change 80211 Reset
command.
Restrictions
Requires privileged user status.
Only applies to the MSS-VIA and certain MSS4 models.
Errors
If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters
RX
Specifies the antennas used to receive
TX
Specifies the antennas used to transmit.
list
Enter an integer or group of integers separated by commas (e.g. 1,2,3) to
specify the affected antenna(s). Antennas are numbered consecutively starting
with antenna number one. See the documentation that came with your card for
antenna numbering information.
Default
Sets the antennas to their default transmit and receive values.
Examples
Local>> CHANGE 80211 ANTENNA RX DEFAULT
Local>> CHANGE 80211 RESET
See Also
CHANGE 80211 ANTENNA
RX
TX
list
DEFAULT