Lantronix MSS - Manual (Page 16)

Command Reference Change 80211
2-7
2.2.8 Change 80211 Power
Controls the card’s transmit power settings. The numeric power setting specified must exactly match a value
supported by the card.
Any configuration changes you make will not take place until you issue the Change 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the MSS-VIA and certain MSS4 models.
Errors If you enter a command that is not applicable to the 802.11 card currently in
use, you will receive an Error message.
Parameters Default
Sets the card to its default transmit power setting.
num
Enter a specific milliWatt power setting.
Examples Local>> CHANGE 80211 POWER DEFAULT
Local>> CHANGE 80211 RESET
See Also Show 80211, page 2-63
2.2.9 Change 80211 Region
Sets the regulatory region under which you will operate the MSS. Users in the United States can leave this
at the default setting (FCC). Other users should set it to correspond with their region.
Any configuration changes you make will not take place until you issue the Change 80211 Reset command.
Restrictions Requires privileged user status.
Only applies to the MSS-VIA and certain MSS4 models.
Errors If you enter a region that will not work with your 802.11 card, an error bit will
be displayed when you enter the Show 80211 command.
CHANGE 80211 POWER
DEFAULT
num  
 
 
CHANGE 80211 REGION
FCC
IC
ETSI
SPAIN
FRANCE
MKK
 
 
 
 
 
 
 
 
 
 
 