Lantronix MSS - Manual (Page 50)

Command Reference Change Retransmit Limit
2-41
Defaults Enabled
2.49 Change Retransmit Limit
‘
Specifies the number of retries attempted if a network message receives no acknowledgment. This number
may need to be increased on noisy or heavily-used networks. The rate at which retransmits are sent is
protocol and network dependent.
Restrictions Requires privileged user status.
Applies to TCP and LAT sessions only.
Parameters Server
MSS4 only.
number
Enter a value between 4 and 100.
Defaults 10
2.50 Change Rlogin
Controls the use of the Rlogin command. Incoming Rlogin connections are always permitted, but when
Rlogin is disabled, users may not log into remote hosts. To view the current status of Rlogin connections,
enter the Show Server command.
Restrictions Requires privileged user status.
Parameters Server
MSS4 only.
Defaults Disabled
CHANGE SERVER RETRANSMIT LIMIT number
CHANGE SERVER RLOGIN
DISABLED
ENABLED
 
 
 