Lantronix MSS - Manual (Page 41)

Command Reference Change Modem Emulation
2-32
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults Disabled
See Also Change Autostart, page 2-12; Change DSRLogout, page 2-22.
2.33 Change Modem Emulation
Presents a modem interface to an attached serial device. The MSS can then accept AT-style modem
commands and handle the modem signals correctly. See your Installation Guide for more details on modem
emulation.
Note: If the MSS is in modem emulation mode and a serial port is idle, the MSS can still
accept network TCP connections to that serial port.
Restrictions Requires privileged user status.
Does not apply to the MSS485.
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults Disabled
See Also Change Autostart, page 2-12; the Using the MSS chapter of your Installation
Guide
2.34 Change Name
Renames the MSS. The unit’s default name, which is based on its default Ethernet address, is printed on its
underside. This name is what will be advertised if WINS is enabled.
Restrictions Requires privileged user status.
CHANGE PORT PortList MODEM EMULATION
DISABLED
ENABLED  
 
 
CHANGE SERVER NAME serverName