Lantronix MSS - Manual (Page 37)

Command Reference Change LAT CircTimer
2-28
Restrictions Requires privileged user status.
The Both, Incoming, and Outgoing parameters are only applicable to the
MSS4.
Parameters IPaddress
Specify an address in standard numeric format. An address with 0 or 255 in any
segment restricts all addresses in that range.
Both
MSS4 only. Restricts logins from the network into the server and TCP sessions
to the network from the server.
Incoming
MSS4 only. Restricts logins from the network into the server, and connections
to the serial port.
Outgoing
MSS4 only. Restricts TCP sessions to the network from the server.
Ports
MSS4 only. Specifies a particular port or group of ports.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges). If a portlist is not specified, all physical and virtual ports
apply.
Defaults Disabled
Examples Change IPsecurity 192.0.220.77 Disabled
(Restricts the single IP address from the table.)
Change IPsecurity 192.0.1.255 Both Disabled
( MSS 4 only: Restricts all addresses between 192.0.1.0 and 192.0.1.255 from both
incoming and outgoing connections.)
2.26 Change LAT CircTimer
Specifies the delay between messages sent from the MSS to other network nodes. This parameter should
not need to be altered, and should not be altered when there are active sessions.
Restrictions Requires privileged user status.
Errors The MSSLite, MSS4, and the MSS-VIA do not support LAT.
Parameters timerValue
Specify a value from 30 to 200 milliseconds.
Defaults 80 (milliseconds)
CHANGE LAT CIRCTIMER timerValue