Lantronix MSS - Manual (Page 45)

Command Reference Change Passflow
2-36
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults None
See Also Change Autobaud, page 2-11; Change Charsize, page 2-16.
2.41 Change Passflow
Specifies whether XON/XOFF characters will be stripped from the data stream. Enabled means that the
MSS will both respond to XON/XOFF and send them to the host. Disabled means that we respond to XON/
XOFF but do not send them to the host. Passflow is only useful when XonXoff flow control is set.
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
See Also Change Flow Control, page 2-23.
CHANGE PORT PortList PASSFLOW
DISABLED
ENABLED  
 
 