Lantronix MSS - Manual (Page 78)

Command Reference Test
2-69
2.102 Test
Tests a serial port’s connection. When the Test command is entered without any parameters, test lines of 70
characters are sent to the specified serial port until a key is pressed.
Restrictions Nonprivileged users may only test their current port.
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a port number as an integer between 1 and 4. You can not specify more
than one port at a time.
DTR
Lowers and then raise the DTR signal on the serial port. If a delay is not
specified, DTR will lower for approximately one second and then raise.
Delay
Lowers DTR will for the specified delay length, then raises DTR.
num
Enter a delay time from 50 to 3,000 (milliseconds).
2.103 Zero
Resets all counters on the MSS (both serial and Ethernet).
Restrictions Requires privileged user status.
TEST PORT PortList DTR DELAY num
ZERO