Lantronix MSS - Manual (Page 72)

Command Reference Set Privileged
2-63
2.85 Set Privileged
Changes the port’s privileged status.
Note: If you forget the password, you must reset the MSS to its factory defaults. See
Initialize on page 2-59 for instructions.
Restrictions Secure users may not become the privileged user.
Only one port at a time can be the privileged port.
Parameters Privileged
Allows a user to become the port’s privileged user, provided the user enters the
correct password.
Override
Forces the current port to become the privileged port (the previous port loses
the privilege).
Noprivileged
Removes privileged status for the port.
See Also Change Privpass, page 2-40.
2.86 Show 80211
Displays the current wireless networking settings. Entering the command without any parameters displays
basic 80211 settings including Region, MAC address, and ESSID. Also displayed are any 802.11 errors,
which are discussed in Appendix B, Show 802.11 Errors.
Errors Only applies to the MSS-VIA and MSS4.
Parameters Antenna
Displays the antenna diversity options (RX and TX) available on the currently
installed 802.11 card.
Power
Displays, in milliWatts, the transmit power settings supported by the currently
installed 802.11 card.
See Also Change 80211, page 2-2; Show 802.11 Errors, page B-1.
SET
PRIVILEGED OVERRIDE
NOPRIVILEGED
 
 
 
 
 
SHOW 80211
ANTENNA
POWER