Lantronix MSS - Manual (Page 56)

Command Reference Change Stopbits
2-47
num
Specify the desired number or retry attempts. Enter zero to make the MSS retry
until the startupfile is read (indefinitely).
Defaults Retry: 5
Examples Local> CHANGE STARTUP FILE “bob:start”
Local> CHANGE STARTUP FILE hevax::start.com
Local> CHANGE STARTUP FILE “engfs\sys:\login\start.cmd”
Local> CHANGE SERVER STARTUP RETRY 6
See Also Change Loadhost, page 2-29; Source, page 2-67.
2.60 Change Stopbits
Specifies how many stop bits the port will use.
Restrictions Requires privileged user status.
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults 1
See Also Change Autobaud, page 2-11; Change Charsize, page 2-16; Change Parity,
page 2-35.
2.61 Change Subnet Mask
Sets an IP subnet mask for the MSS. The mask is applied to target IP addresses to determine whether the
destination address is on the local network segment. If the address is not on the local segment, the MSS’s
gateway host will be accessed to provide the connection. A mask is created by default when the IP address
is first set, but can be overridden with this command.
CHANGE PORT PortList STOPBITS
1
2
 
 
 
CHANGE SERVER SUBNET MASK mask