Lantronix MSS - Manual (Page 52)

Command Reference Change Secondary
2-43
TXDrive
Controls how the MSS drives the TX pin.
Always
Sets the MSS to drive TX. The MSS will never tristate TX, even if data is not
being sent.
Auto
Sets the MSS to drive TX only when transmitting, and tristate when not
transmitting.
Defaults Disabled
Mode = 4Wire
Termination disabled
TXDrive = Always
2.52 Change Secondary
Users can configure a secondary gateway, loadhost, and/or nameserver in case the primaries are
unreachable. For information, please see the Change Gateway (page 2-24), Change Loadhost (page 2-29),
and Change Nameserver (page 2-33) command entries.
2.53 Change Session Limit
Sets a server-wide limit for active sessions per port.
Restrictions Requires privileged user status.
Parameters Server
MSS4 only.
number
Enter a value between 0 and 8.
Defaults 4
2.54 Change Signal Check
Determines whether the MSS will check for the DSR signal when connections are made from the network
to a serial port. If the DSR signal is not present, the connection will be rejected.
CHANGE SERVER SESSION LIMIT number
CHANGE PORT PortList SIGNAL CHECK
DISABLED
ENABLED  
 
 