Nortel Networks Sun Fire V210 (RoHS) User Manual
Page 42
NN42020-310 MCS 5100 3.5 Standard 1.0 June 2006
42
Copyright © Nortel Networks Limited 2006
7
Enter your password: system [Enter]
8
Define server ip address <IP address of the terminal server>
[Enter]
9
Define server ip subnet mask <ip-address of the subnet
mask> [Enter]
10
Define server ip primary gateway address <ip address of the
primary gateway> [Enter]
11
Define port:<select port from range 1-18> telnet newline
filtering cr [Enter]
Note: Type a range [1-18] for every port the Sun Fire V210
server is connected to.
12
Define port for use with SMDI: Define port 19 telnet newline
filtering none
Note: You can verify the ports with the command:show
ports 1-19 telnet chara [Enter]
13
Save your changes.
14
Log out.
Note: Using the command define saves the configuration.
15
To kill a session on a port, type: logout port 12 [Enter]
Procedure 9 Connecting a server to the MRV LX terminal server
At the management pc,
1
Connect a cat-5 Ethernet cable from the management PC to the
layer-2 switch.
2
Launch PuTTY.
Note: Refer to the customer-specific information datasheet to
enter the MRV LX terminal server IP address and the port
number.
3
In the hostname field, enter <IP address of the MRV LX
terminal server>
ATTENTION
The procedures in this document assume that you are using
PuTTY. It is suggested that you download from the web, PuTTY
VT 100 Emulator, a freeware configurator tool to set up sessions.
Download PuTTY from