Nortel Networks Sun Fire V210 (RoHS) - Manual (Page 79)

MCS 2-server Sun Fire V210 (RoHS) Solaris Installation and Commissioning Guide
79 Copyright © Nortel Networks Limited 2006
7 Will a Motorola SAM16 server (SIP PriGwy or SIP
Audio Svr) be deployed? [Y/N]
Always answer N [Enter] even if you have a third-party
gateway.
Note: Information obtained for deploying the Sysmgr
appears.
8 Is the above data correct? [Y]
Answer Y [Enter]
9 Start up the SysMgr and TSS processes? [Y]
Answer Y [Enter]
Note: You must wait until the system returns to prompt since
the system does a sleep message as it starts each service.
There may be a delay.
Sysmgr deployment verification
After completing step 9 above, the screen will display deployment
information. Notice that the script waits 30 seconds between process
executions. The script is starting three processes that must be running
in order to continue MCS load deployment.
The three processes can be verified by opening a PuTTY SSH session
to the management / accounting server.
Example: Open a PuTTY SSH session to 120.120.13.22
Procedure 23 Verifying the Sysmgr deployment
At the management pc,
1 Log into management / accounting server as nortel / <your new
password>.
2 Execute the following command to verify processes:
[@micromgmt] /export/home/nortel:=> meinit -p
Rel3 NTme_pids mgmtsvr mgmtsvr.3 xxxx
Rel3 NTme_pids tsscma tsscma.5 xxxx
Rel3 NTme_pids tssfpma tssfpma.6 xxxx
Note: The numerical value of the PIDs is shown as "xxxx"
because it may vary on each system.
The results of the meinit command should display three
processes along with their process ids.