Nortel Networks Sun Fire V210 (RoHS) User Manual
Page 63
MCS 2-server Sun Fire V210 (RoHS) Solaris Installation and Commissioning Guide
63
Copyright © Nortel Networks Limited 2006
Is this IPMP group configuration acceptable?
(Y/N)
Select Y to accept or N to change.
14
The default route IP address should appear. If correct, press
Enter. Otherwise, type it in, then press Enter.
Note: If your configuration does not include a router, then
enter the machine logical IP address of your server.
15
Do you intend to deploy the Web Server to this
machine (y,n)?
Enter Y.
16
You are now configuring the Syslog Daemon.
Press
Enter to continue.
17
Does the Management Server have a SysMgr Service
Logical IP Address [Y/N]?
Select N.
18
Press Enter to configure the LOM port.
You will need to enter the following information:
• IP address for the Physical Ethernet Net Management port
• Netmask for the Physical Ethernet New Management port
• Gateway IP address
Note: If the Net Management port was previously configured,
the IP address, Netmask address, and Gateway address are
shown as the defaults for the entries in steps 19, 20, and 21
below. Press Enter to accept the default IP addresses.
19
Enter the <IP address for the Physical Ethernet Net
Management Port> (Default: 0.0.0.0)
20
Enter the <netmask for the Physical Ethernet Net
Management Port> (Default: 255.255.255.0)
21
Enter the <Gateway IP address> (Default: 0.0.0.0)
You are asked to confirm the LOM port configuration.
22
Type Y to accept the LOM port configuration or N if you want to
change something.
The system will now reboot and come up requesting that you
insert CD5.
ATTENTION
If you are not prompted for CD5, contact support.