Installing oracle 9.2.0.4 on the database server, Installing oracle 9.2.0.4 – Nortel Networks Sun Fire V210 (RoHS) User Manual
Page 71
MCS 2-server Sun Fire V210 (RoHS) Solaris Installation and Commissioning Guide
Copyright © Nortel Networks Limited 2006
Installing Oracle 9.2.0.4 on the database
server
The procedures to install Oracle 9 on the DBSvr include storing Oracle
9 CDs 1-6 to your local hard drive. Refer to the section that follows.
Approximate time for loading Oracle 9 = 90 minutes
Installing Oracle 9.2.0.4
Procedure 20 Installing Oracle 9.2.0.4 on the database server
(DBSvr)
At the management pc,
1
Use PuTTY to connect to the database server using Serial MGT
port, which connects to the LX terminal server.
2
Log in as root to the Management/Accounting server.
3
Enter your <customer-specific password>.
4
Enable the CD-ROM auto mount by typing the following
command: /etc/init.d/volmgt start
You will see the message: volume management starting.
5
Insert Oracle 9.2.0.4 CD 1 into the CD-ROM drive on the server.
6
cd [ space] /cdrom/cdrom0 [Enter]
ATTENTION
Refer to the CSI datasheet for such items as the hostname, IP
addresses, and subnet masks.
ATTENTION
Perform these steps on all servers in parallel if multiple CDs are
available.