Nortel Networks Sun Fire V210 (RoHS) - Manual (Page 75)

MCS 2-server Sun Fire V210 (RoHS) Solaris Installation and Commissioning Guide
Copyright © Nortel Networks Limited 2006
Deploying the initial database load
Prerequisites
Ensure that the MCS Base Platform Software and Oracle 9i have been
installed on database servers.
Deploying the MCS database load (imssipdb)
After performing the steps for installing MCS Base Platform software
and Oracle software, an empty imsdb1 database is all that exists. A
database load must be deployed on the database machine (Server1) to
define all of the MCS schemas and configurations.
Commands are executed on each server using PuTTY SSH into the
machine logical IP address (ex.: 120.120.13.25). The procedure to
install the database load for the first time is command-line driven and
executed from the MgmtSvr.
Example: Open a PuTTY SSH session to Server1 120.120.13.22
Procedure 21 Deploying the initial database load (imssipdb)
At the management pc,
1 Log into the MgmtSvr:
User name: <nortel>
Password: <your new password>
2 Execute the following command: dbdeploy.pl [Enter]
3 Select the correct database load and press Enter.
4 Is this a Replicated Database? Enter N for a
non-redundant system.
ATTENTION
Refer to your CSI datasheet to enter the IP addresses that you
are prompted for in this section.