Nortel Networks Sun Fire V210 (RoHS) - Manual (Page 57)

MCS 2-server Sun Fire V210 (RoHS) Solaris Installation and Commissioning Guide
57 Copyright © Nortel Networks Limited 2006
7 Press Enter to continue.
8 You will see the following statement:
”You are now configuring IPMP (Multipathing)"
”Please have the Database Server Physical IP
addresses and the Machine Logical IP address
ready. Have 6 IP addresses that can be used as
ping buddies." Recommendations for ping buddies
are provided.
9 Press the Enter key to continue.
10 When you see the IP multipathing configuration for Sun Solaris
information appear, press Enter to accept it or type in a
preferred setting. The default failover timeout is set to
1000mSec.
11 Enter the primary machine physical IP address for the bge0
interface: <Physical IP address of the bge0
interface> [Enter]
Example: 120.120.13.20
12 Enter the secondary machine physical IP address for the bge1
interface:
<Physical IP address of the bge1 interface>
[Enter]
Example: 120.120.13.21
13 Enter the <machine logical IP addresses of the
servers>
that are the ping targets.
Note: Do not enter the IP address of the server you are
working on.
IP Multipathing needs a set of reliable hosts to ping against.
Select a set of three IP addresses in this subnet that belong to
reliable nodes (such as fault tolerant servers). Select the three
nodes from the following list, in order of preference:
For IPMP GROUPS:
• Machine Logical IP address of the database server
• Machine Logical IP address of the Management server
• Machine Logical IP address of the CAM server
• BPS stack IP address
• Other optional devices (PRI Gateway host)