NCR S10XL - Manual (Page 100)

Using the System Utilities
Using the EISA Configuration Utility
5-14 NCR S10XL Hot Plug Server User Guide
If your system comes configured with 16 MB or
more of system memory, and your system is
configured with an add-on card that requires the use
of memory in the 15-16 MB range, select 16 MB Ext
Memory with 15-16 MB Add-On Card Used.
5. After making the appropriate selection, press
[Enter]. You are returned to the system baseboard
configuration screen.
6. If your system is configured with more than 16 MB
of system memory, press [Control] + [R] to select 16
- 64 MB Extended Memory - - - - - - - CTRL-R to add
the Memory.
7. Observe the following memory configuration
screen:
Memory Address (-) 16 M Type: SYSTEM
Size 0
(value between 0 - 48M,
in increments of 4M)
8. Tab to the size (amount of memory in range) field.
If your system has 64 MB or more of system
memory, enter 48M.
If your system has less than 64 MB of system
memory, subtract 16 MB from the amount of total
system memory and enter that value in this field.
For example, if your system has 24 MB of total
system memory, subtract 16 MB from 24 MB to get 8