NCR S10XL - Manual (Page 38)

Configuring the System Board
Installing Drives
2-18 NCR S10XL Hot Plug Server User Guide
Installing Drives
Read the “ESD Precautions” section earlier in this
chapter before proceeding.
This section describes in detail how to install disk drives
in the system.
When installing drives on the 5.25-inch drive bays, you
have to remove both the upper front panel cover and its
frame. Follow these steps:
1. To remove the front panel cover, hold it on both
sides and pull.
2. To remove the upper front panel frame, press the
latch under it and pull as shown in Figure 2-9.
Caution
Removing the Upper
Front Panel Cover and
Frame
Figure 2-9
Removing the Upper Front Panel
Cover and Frame