NCR S10XL - Manual (Page 133)

Sample Configurations
Sample RAID Configuration
NCR S10XL Hot Plug Server User Guide C-13
4. Strap the four 4 GB wide drives as SCSI IDs 0, 1, 2,
3. Plug them into the hot plug backplane in drive
bays 5, 6, 7, and 8 (bottom four drive bays).
5. Install the memory SIMMs in banks one and two on
the system baseboard (installed in groups of two
SIMMs).
6. Install the PCI Ethernet Adapter in PCI slot 1
(topmost PCI slot).
7. Install the PCI Token Ring Adapter in PCI slot 2.
8. Install the PCI RAID Adapter in PCI slot 3.
The procedure is the same as the procedure for
configuring the system settings in the Standard
Configuration. The procedure is repeated here for your
convenience.
To configure the system settings, follow these steps:
1. Turn on power to the system. Observe that the
memory test is executed (memory addresses should
be rapidly displayed in upper left-hand corner of
screen). Ignore any memory size mismatch error
displayed on the screen.
2. Press [Control] + [Alt] + [Esc] when prompted to
enter the BIOS Setup Utility.
3. Select Load System Setup Defaults and press
[Enter].
Configuring the
System Settings