NCR S10XL - Manual (Page 116)

Error Messages
System Error Messages
B-4 NCR S10XL Hot Plug Server User Guide
Message Action
Equipment configuration error Modify DRAM configuration to agree with one of the
options in the memory configuration shown in Figure
4-4.
Fixed disk controller error Run Setup.
Fixed disk 0 error Check all cable connections. Replace fixed disk.
Fixed disk 1 error Check all cable connections. Replace fixed disk.
Keyboard error or no keyboard
connected Check and connect the keyboard to the system unit.
Keyboard interface error Replace the keyboard or contact your dealer.
Memory error at:
MMMM:SSSS:OOO
(W:XXXX,R:YYYY)
where M is MB, S is Segment, O is
Offset, X/Y is write/read pattern
Check the memory size based on the system
specifications. Check the internal cable connections. If
you are sure that connections and values are correct,
ignore the message. If the message reappears, ask for
technical assistance.
Onboard serial port 1 conflict Run Setup and disable the port.
Onboard serial port 2 conflict Run Setup and disable the port.
Onboard parallel port conflict Run Setup and disable the port.
Pointing device error Check and connect pointing device.
Pointing device interface error Replace the pointing device or contact your dealer.
Press F1 key to continue or
Ctrl-Alt-Esc for setup Press [F1] or [Control] + [Alt] + [Esc].