NCR S10XL - Manual (Page 70)

Using the BIOS Setup Utility
PCI System Configuration
4-18 NCR S10XL Hot Plug Server User Guide
PCI devices support the “palette snooping” technique
that enables the device to control access to their palette
registers.
Set this parameter to Enabled to activate the palette
snooping function in the PCI VGA devices installed in
your system. Check your VGA card manual for more
information about this function.
This parameter enables/disables the on board SCSI
AIC-7870.
Boot Device
During POST, the normal booting procedure starts with
the initialization of the ISA card, followed by the PCI
card, then the onboard SCSI, if present. Enabling this
parameter changes the normal booting sequence of the
system, doing the SCSI initialization prior to add-on
PCI card initialization. You can only set this parameter if
the On Board SCSI parameter is set to Enabled. The
default setting is Disabled.
VGA Palette Snoop
On Board SCSI