NCR S10XL - Manual (Page 32)

Configuring the System Board
SCSI Feature
2-12 NCR S10XL Hot Plug Server User Guide
SCSI Feature
The system board features a single-chip Fast and Wide
SCSI-2 host adapter that adds SCSI I/O capability to the
system.
The chipset consists of all the components found on the
state-of-the-art SCSI host adapters such as the
following:
•
Onboard microcontroller
•
Bus master interface controller
•
SCSI controller
The chipset allows transfers at a full 20 MB/second
burst transfer rate.
To use the feature, install any SCSI device in your
system and connect it to the SCSI interface on the
system board. (See Figure 2-1 for the location.) Then,
enter the BIOS utility to set the PCI slot parameters. See
Chapter 4, “Using the BIOS Setup Utility”, for details in
setting the parameters. Refer to the SCSI manual for
more information on using SCSI.
Onboard terminators (RP12, RP13, and RP14)
must be removed when using wide drives. Ensure that
terminators are on when only narrow drives are used.
Note: