NCR S10XL - Manual (Page 31)

Configuring the System Board
Installing SIMMs
NCR S10XL Hot Plug Server User Guide 2-11
3. Pull the SIMM out of the socket.
Reconfigure the system after installing or removing
SIMMs.
To reconfigure the system, follow these steps:
1. Reboot the system. A memory error message
appears, indicating that the total memory does not
match the value stored in CMOS.
2. Boot the system with the EISA Configuration Utility
(ECU) diskette, and configure the baseboard settings
for the proper amount of memory. Follow the steps
under the heading, “Configuring the System
Memory” in Chapter 5.
Reconfiguring the
System