NCR S10XL - Manual (Page 99)

Using the System Utilities
Using the EISA Configuration Utility
NCR S10XL Hot Plug Server User Guide 5-13
To use the ECU to configure the system, follow these
steps:
1. Boot the system with the ECU diskette.
2. Select the system baseboard from the configuration
screen.
3. Select 4 - 16 MB Extended Memory from the system
baseboard configuration screen. The following
options display:
4 MB Ext Memory
8 MB Ext Memory
12 MB Ext Memory
16 MB Ext Memory with 15-16 MB System Used
16 MB Ext Memory with 15-16 MB Add-on card
used (Pentium used only)
4. Make the selection that is appropriate for your
system configuration.
For example, if your system comes configured with
4 MB of system memory, select 4 MB Ext Memory. If
your system comes configured with 8 MB of system
memory, select 8 MB Ext Memory. If your system
comes configured with 12 MB of system memory,
select 12 MB Ext Memory.
If your system comes configured with 16 MB or
more of system memory, and your system is not
configured with an add-on card that requires the use
of memory in the 15-16 MB range, select 16 MB Ext
Memory with 15-16 MB System Used.