NCR S10XL - Manual (Page 129)

Sample Configurations
Sample Standard Configuration
NCR S10XL Hot Plug Server User Guide C-9
4. Select SCSI Device Configuration and set the
parameters as follows:
SCSI Device ID (tab to desired device)
Initiate Sync Negotiation
[yes]
Maximum Sync Transfer Rate [20]
Enable Disconnection [yes]
Initiate Wide Negotiation [yes]
Send Start Unit Command [yes]
5. Press [Enter] to return to previous menu.
6. Select Advanced Configuration Options and set the
parameters as follows:
Host Adapter BIOS (Config Util...) [Enabled]
Support Removable Disks... [Boot Only]
Extended BIOS Translation... [Enabled]
Display <CTRL-A> Message During
BIOS Initialization... [Enabled]
Multiple LUN Support [Disabled]
BIOS Support for More than 2... [Enabled]
7. Press [Enter] to return to previous menu.
8. Press [Esc] until prompted to save configuration.
Save the configuration and the system reboots.
Sometimes the EISA Configuration Utility will not boot.
If this happens, perform the following procedure:
1. Using the BIOS Setup Utility, disable all PCI
adapters.
2. Boot the EISA Configuration Utility.
Configuring the
Memory and Other
Baseboard Settings