Nortel Networks BCM1000 - Manual (Page 124)

124 Chapter 5 Installing the BCM1000
P0607659 02
Installing the BCM1000 into the rack
After the brackets are installed, perform the following steps to install the BCM1000 in the
equipment rack:
1 Determine the location in the rack you want to install the base unit.
2 Position the base unit in the rack.
3 Align the holes in the rack mounting bracket with the holes in the equipment rack rails.
4 Fasten the rack mounting brackets to the rack using four screws (not supplied).
Refer to Figure 41 .
Figure 41 Fasten the BCM1000 to the equipment rack