Nortel Networks BCM1000 - Manual (Page 223)

Chapter 13 Installing Analog Terminal Adapters 223
Installation and Maintenance Guide
Configuring the ATA 2
Configure the ATA 2 using Business Communications Manager Unified Manager. For detailed
information about using Unified Manager, refer to the Business Communications Manager
Programming Operations Guide.
1 Open the Unified Manager.
2 Assign the following line features to the ATA 2:
• assign one external line to the telephone
• set ringing for this line ON or OFF, as required
• assign one intercom line
• assign Held Line Reminder to ON
• disable Full Handsfree
• disable Handsfree Answerback
• disable Paging Reception
3 Assign an external line, an intercom line, or a line pool as the Prime Line for the ATA 2.
4 Exit the Unified Manager.
5 Set the ATA 2 to Tones ON when you are assigning an analog voice device.
Set the ATA 2 to Tones OFF when you are assigning a data communication device.
For details, refer to the Business Communications Manager ATA2 User Guide. The default is
Tones OFF.
Testing the ATA 2
Confirm that the ATA 2 is operating by connecting a single-line telephone to the ATA 2. Make an
internal call and an external call using the telephone connected to the ATA 2. Next, call the ATA 2
from an system telephone. Refer to the Business Communications Manager ATA2 User Guide for
details.
Note: Direct access to a CO line for modems, fax machines and credit card verification
machines is possible using the Hotline feature. For direct access to a CO line, program an
external line as the Hotline. Enter a pause to replace the telephone number for the Hotline
(F78).