Nortel Networks BCM1000 - Manual (Page 171)

Chapter 9 Starting the system 171
Installation and Maintenance Guide
Figure 60 Main Menu
9 What information you want to configure, will determine your next steps:
• If you only want to change the IP addressing, enter 2 (System Configuration) and follow
the prompts.
• If you want to configure the system through the serial port, enter 3 (Configuration
Wizard). This wizard also allows you to change the IP addressing information.
This Wizard has the same information as the Quick Start Wizard that you access through
the Unified Manager, but in a slightly different format. Refer to the Business
Communications Manager Programming Operations Guide for a detailed description of
the fields that occur in the Configuration Wizard
Note: When you change IP address, Region, Template and/or Start DN, the system
prompts you for a restart after you accept the changes.
After the system restarts, you can continue with your system configuration.
Warning: Changing this information on an existing system completely erases the
telephony programming and disables the telephony system. It also reboots the BCM1000
and BCM1000e, if there is one.