Nortel Networks BCM1000 User Manual
Page 31
BCM1000, BCM 3.0.1 addendum 31
P0607659 02
BCM1000 Installation and Maintenance Guide
Figure 6 Quick start page
12 Enter the correct information for LAN1 (a), LAN2 (i), Subnet masks (m and j), Default next hop
router (r) and System name (s), as required. Enter p after each change to apply it.
13 Enter b (go back) to return to the System Configuration Start Page screen after all network IP
addresses are configured.
14 Enter r to reboot the system and to apply the network IP address changes
15. Do one of the following:
• Run the Quick Start Wizard and manually reconfigure your system.
• Run the Quick Start Wizard to create the system parameters and defaults. Then restore your system
data from your backup disk.
• Restore system and data information from your backup disk.
16 Test your system for correct operations.
Warning: You can only perform a restore from a current backup disk that was backed up from the
same software version as your system is currently running. In this case, if you do not have a backup
that was run on a version 3.0.1, you need to manually reenter your data.