Figure 135 securing the power supply bracket, Make internal, Connections – Nortel Networks BCM1000 User Manual
Page 275
Chapter 19 Replacing a power supply
275
Installation and Maintenance Guide
5
Insert the power supply bracket and secure it with a screw. Refer to
Figure 135
Securing the power supply bracket
6
If you have not already done so, install a redundant fan into the unit. Refer to
replacing a cooling fan” on page 261
.
7
Inside the cabinet, reconnect the power supply and fan cables.
8
Reconnect the power supply and fan cables.
9
Replace the cover.
10
Ensure that you position the power modules correctly before inserting them into the power
supply housing.
a
The green LED sits at the top of the unit.
b
Check the rocker switch on the left side of the module and ensure that it is in the OFF
position.
Notes Layer:
Remember to Hide the Single Power Supply Layer
When Dual Power Layer and Dual Fan Layer are Visib
Power supply bracket screw