National Instruments AT E Series - Manual (Page 133)

Appendix A Specifications for AT-MIO-16XE-10 and AT-AI-16XE-10
AT E Series User Manual A-28 ni.com
Calibration
Recommended warm-up time.................15 min
Calibration interval .................................1 year
External calibration reference.................>6 and <9.999V
Onboard calibration reference
Level ................................................5.000 V (±1.0 mV) (over full
operating temperature, actual
value stored in EEPROM)
Temperature coefficient...................±0.6 ppm/°C max
Long-term stability ..........................±6 ppm/
Bus Interface
Type ........................................................Slave
Power Requirement
+5 VDC (±5%) .......................................1.2 A
Power available at I/O connector............+4.65 VDC to +5.25 VDC
at 1 A
Physical
Dimensions
(not including connectors) ......................33.8 by 9.9 cm
(13.3 by 3.9 in)
I/O connector ..........................................68-pin male SCSI-II type
Maximum Working Voltage
Maximum working voltage refers to the signal voltage plus the
common-mode voltage.
Channel-to-earth .....................................42 V, Installation Category II
Channel-to-channel.................................42 V, Installation Category II
1,000 h