National Instruments AT E Series - Manual (Page 18)

Chapter 1 Introduction
AT E Series User Manual 1-6 ni.com
Unpacking
The AT E Series device is shipped in an antistatic package to prevent
electrostatic damage to the device. Electrostatic discharge can damage
several components on the device.
Caution Never touch the exposed pins of connectors.
To avoid such damage in handling the device, take the following
precautions:
• Ground yourself using a grounding strap or by holding a grounded
object.
• Touch the antistatic package to a metal part of the computer chassis
before removing the device from the package.
Remove the device from the package and inspect the device for loose
components or any sign of damage. Notify NI if the device appears
damaged in any way. Do not install a damaged device into the computer.
Store the AT E Series device in the antistatic envelope when not in use.
Safety Information
The following section contains important safety information that you must
follow during installation and use of the product.
Do not operate the product in a manner not specified in this document.
Misuse of the product can result in a hazard. You can compromise the
safety protection built into the product if the product is damaged in any
way. If the product is damaged, return it to NI for repair.
If the product is rated for use with hazardous voltages (>30 V
rms
, 42.4 V
pk
,
or 60 V
dc
), you may need to connect a safety earth-ground wire according
to the installation instructions. Refer to Appendix A, Specifications , for
maximum voltage ratings.
Do not substitute parts or modify the product. Use the product only with
the chassis, modules, accessories, and cables specified in the installation
instructions. You must have all covers and filler panels installed during
operation of the product.
Do not operate the product in an explosive atmosphere or where there may
be flammable gases or fumes. Operate the product only at or below the