Ricoh AP4510 - Manual (Page 104)

Paper and Other Media
30
3
• The Bypass Tray supports custom size paper approximately 100 to 297 mm
(3.9 to 11.7 inches) in width, and approximately 148 to 432 mm (5.8 to 17
inches) in length.
❖ ❖ ❖ ❖ Thick Paper
• Thick paper here means paper between 106 g/m 2 (28 lb. bond) to 163 g/m 2
(43 lb. bond).
• Use the Bypass Tray. Other input trays cannot be used.
• The Bypass Tray can hold paper up to 163 g/m
2 (43 lb. bond) in weight.
The print quality is not guaranteed for paper thicker than this.
• Confirm that the top of the stack is not higher than the limit mark inside
the tray.
• When printing on thick paper, select the thick paper mode with the control
panel or the printer driver.
❖ ❖ ❖ ❖ OHP transparencies
• Use the Bypass Tray. Other trays cannot be used.
• Separate stuck OHP transparencies each time before printing.
• If OHP transparencies stick together when they feed, set them on the tray
one by one or select "Slip sheet" in the printer driver. For more information
about using "Slip sheet", see the printer driver's Help file.
• Confirm that the top of the stack is not higher than the limit mark inside
the tray.
• When printing on OHP transparencies, select the OHP transparency mode
with the control panel or the printer driver.
• Remove OHP transparencies from the tray after use to prevent them from
sticking to each other.
❖ ❖ ❖ ❖ Envelopes
• Use the Bypass Tray. Other trays cannot be used.
• Load envelopes in the Bypass Tray with the print side down, the flaps
closed and the sides in the feeding direction.
A : Must be 100 mm (3.9 inches) or longer.
B : Must be 148 mm (5.8 inches) or longer.