Ricoh AP4510 - Manual (Page 142)

Troubleshooting
68
5
Error: HDD An error has occurred in the
optional Printer Hard Disk. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Turn off the power switch. Re-
place the Printer Hard Disk
and turn on the power switch.
See “Installing Printer Hard
Disk Type 4510” in the Setup
Guide.
Turn off the power switch. Re-
move the Printer Hard Disk
and turn on the power switch.
Note
❒ If the Printer Hard Disk is
not installed, you cannot
send the Sample Print job,
Locked Print job or down-
load the font to Printer
Hard Disk using the PS
Utility for Mac.
Error: IEEE 1394 An error has occurred in the
optional 1394 Interface Unit. First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Turn off the power switch. Re-
place the 1394 Interface Unit
and turn on the power switch.
See “Installing 1394 Interface
Unit Type 4510” in the Setup
Guide.
Turn off the power switch, re-
move the 1394 Interface Unit
and turn on the power switch.
Note
❒ If you remove the 1394 In-
terface Unit, you cannot
send print jobs via the 1394
Interface Unit. You can
only send print jobs to the
printer via the parallel ca-
ble connection.
Error: NVRAM The printer detected a Memo-
ry Switch error. Remove and reinstall the NV-
RAM.
Messages Description Solution