Ricoh AP4510 - Manual (Page 153)

Other Printing Problems
79
5
Note
❒ If the problem cannot be solved, contact your sales or service representative.
The control panel error message
stays on after removing the mis-
fed paper. Open the front cover of the printer and then close it. See p.80
“Removing Misfed Paper”.
Paper is not fed from the select-
ed tray. Check the paper size settings. The size selected with the pa-
per size dial might be different from the actual paper size.
Make the correct dial setting.
See p.33 “Loading Paper and Other Media”.
When using the Bypass Tray, set the paper size using the
control panel.
See p.33 “Loading Paper and Other Media”.
When you are using a Windows operating system, the print-
er driver settings override those set using the control panel.
Set the desired output tray using the printer driver. See the
driver's online Help file.
The printed image is different
from the image on the compu-
ter. When you use some functions, such as enlargement and re-
duction, the layout of the image might be different from that
shown in the computer display.
It takes too much time to resume
printing. The data is so large or complex that it takes time to process
it. If the Data In indicator is blinking, the data processing is
being done. Just wait until it resumes.
Changing the paper feed direction may sometimes reduce
the time to resume printing.
The image is printed in the
wrong orientation. Set the correct orientation under the “PCL Menu” with the
control panel. See p.127 “PCL Menu”.
Confirm that the setting of orientation has been set in the ap-
plication you use.
Set the correct paper size and feed direction that matches
tray settings on the RPCS printer driver.
Part of the image cannot be
printed. A paper size which is smaller than that selected in the appli-
cation is used for printing. Load the correct size of paper.
Network configurations you
have made do not become effec-
tive. Print a configuration page and check the network settings.
Status Possible Causes, Descriptions, and Solutions